• Contents:  (9) 18"x 32" (9) 457mm x 812mm* pieces of Dynamat Xtreme
• Application: Use on rear decks, doors, floors and the floor of your trunk to get more bass, more music, lower road noise and better sound. 
• High-performance Dynamat Xtreme is lighter than Dynamat Original, four times more effective, requires no heat to apply and is recommended for vehicle tops, sides and contoured areas. Dynamat Xtreme is coated with aluminum for high temperature areas such as firewalls and floors. Depending on your needs, choose Dynamat Xtreme in either application-specific kits (pre-cut material in appropriately-sized pieces) or in sheets you can cut to fit.

• Extreme Trunk Kit
• 5 Sheets - 20 Sq. Ft. Total

• Used on the trunk floor to maximize bass and to reduce road noise. Kit contains Dynamat Xtreme for trunk side panels and trunk lid.

• Four11.5"x 32" (4) 292mm x 812mm* pieces of Dynamat Xtreme
• Four Doors Application
  

• One 24" x 36" x 0.5"  (1) 609mm  x 914mm x 13mm* piece of Extremeliner

• Extremeliner is the ultimate low-frequency attenuator.  Extremeliner is a four-part composite barrier consisting of 1/8 inch layer of neoprene, 15 mils of acoustic lead barrier, 1/4 inch layer of high efficiency acoustic foam and a 3 mil urethane top facing.  Extremeliner works anywhere on your vehicle's floor and firewall for the ultimate barrier against road and engine noise. 

Appearance: 4-Layer Acoustical foam barrier with black urethane surface
Thickness: 0.392 inches
Mass: 1.5 lb./ft2
Temperature Resistance Range: -54C to +149C (-65F to +300F)
Chemical Resistance: Resistant to water and mineral oils
Adhesive Peel Strength: 74.81 N/min on cold steel
Fire Classification: Meets FMVSS 302
Handling And Application: The material must be at room temperature before handling and application
Storage Information: Temperature Range: 32F to 86F
Number of Sheets in Stack:200 Maximum
This material must be stored horizontally in its wrapping

• One 18"x 32" (1) 457mm x 812mm* pieces of Dynamat Xtreme

• Dynamat Xtreme to be used on rear decks, doors, floors and the floor of your trunk to get more bass, more music, lower road noise and better sound. Xtreme is also recommended for trunk lids, roofs, quarter panels and under hood installations.

  
  

Dynamat XTREME is a butyl composite with aluminum constraining layer, sheet metal vibrational damper.  Dynamat XTREME is made to conform and fuse to sheet metal and other hard substrates: automotive body surfaces such as floor pans and doors.  Product can be die cut to shape and placed onto the body surface after sheet metal cleaning operation and prior to paint system (typically a t the sealer application operation) or on painted panels.  Material can withstand temperature ranges between -54°C to +149°C (-65°F to +300°F) and is highly resistant to aging.

• Kit Contains:
• Two 6" x 6" Dynaxorb squares
• Two 155mm x 155mm Dynaxorb squares
• Dynaxorb eliminates back-wave speaker distortion that colors sound and confuses imaging by using a combination of energy absorbent material and the technology known as “faceting". Designed for installation behind speakers and in subwoofer enclosures.
  

• One 2" wide solid rubber roller (1) 50mm wide solid rubber roller

• Professional tool for applying Dynamat and ensuring proper adhesion with professional-looking results.
  

  
  
  

• One 1.125" wide hardwood roller (1) 29mm wide hardwood roller

• Economical tool for applying Dynamat and ensuring proper adhesion.